Features & Benefits
- New Improved Formula
- Apply and hand buff High SiO2% coating solution.
- High Level of Beading and Sheeting.
- Super Hydrophobic.
- Super High Gloss Finish.
Lasts over 3 months as an effective hydrophobic nano coating.
Application is easy just apply a small amount to a microfiber cloth (around the size of a 5 cent piece). Spread over panel, leave for 30 seconds to a minute, and buff away the residue and your done! High quality nano technology coating.
Directions for Use
Ultimate Nano Coat should be applied with care and we recommend following both preparation instructions and application instructions below to get the best result. Ensure your vehicle is clean and dry – and is in a shaded area out of sunlight. Ideally you will need Ultimate Nano Coat, Ultimate Paintwork Cleaner + 2 or more Microfibre Cloths.
Preparation
Start by thoroughly washing your vehicle first using a wax & sealant free car shampoo. During the wash process we recommend degreasing the surface with Fireball Ultimate Paintwork Cleaner. Ultimate Paintwork Cleaner removes any traces of existing waxes, sealants and polishes – allowing Ultimate Nano Coat to bond to the paintwork. After degreasing then dry your vehicle and move it into the shade.
Application
Shake Ultimate Nano Coat thoroughly before use (for at least 10-20 seconds). Using the provided ‘witches cap’ apply a small line of product to either a Fireball Applicator or Fireball Suede Cloth. Spread the product thoroughly across the surface; working one panel at a time. If you feel as though the product is ‘tacking’ on application use a bit more. If you feel as though it’s hard to remove, use less. After applying one section wait for up to 1 minute before buffing off excess product with a clean microfibre towel. Repeat on all panels until complete. We recommend giving the entire vehicle one final buff with a clean microfibre after application to remove any high spots.
Notes
The microfibres you use are likely to harden. To stop this from happening immediately wash in warm water and check thoroughly after before deciding to use those microfibres on any other surface. Ultimate Nano Coat takes 24 hours to cure; so any freshly coated vehicle should not come in contact with any water for at least that amount of time.
